Note: Due to technical difficulties, the Archives are currently not up to date.
GMANE provides an alternative service for most mailing lists. c.f. bug 424647
agtdino pisze:
> Hello, I'm trying to configure a Access Point with ralink rt61,
> when I run /etc/init.d/hostapd start say something that don't
> exist /dev/wlan0 but ralink device is /dev/ra0. I've read that HostAPd
> cannot run on any other device that non Atheros, (madwifi-ng) or
> Prism :(
>
> Any help will be apreciated.
>
> Thank and regards
>
>
Ok, if You use hostAP you should have WiFi card that allows to run in AP
mode - most of new cards have it. But when hostAP was written, only
couple chipsets have ability to run in AP. If You cannot run on RT/RA
link card with hostAP, there is some probability, that this card is not
supported with hostAP packege. I've having RT/RaLink card on PCMCIA but,
this card can run in AP mode under windows only with WINDOWS DRIVERS.
Simple: hostap is not packege for Your card.
PS: ndiswrapper allso don't work.
--
gentoo-amd64@g.o mailing list
|
|
