Gentoo Logo
Gentoo Spaceship




Note: Due to technical difficulties, the Archives are currently not up to date. GMANE provides an alternative service for most mailing lists.
c.f. bug 424647
List Archive: gentoo-desktop
Navigation:
Lists: gentoo-desktop: < Prev By Thread Next > < Prev By Date Next >
Headers:
To: gentoo-desktop@g.o
From: Harry Holt <harryholt@...>
Subject: Re: unsubscribe
Date: Sat, 31 Jan 2009 23:23:58 -0500
<br><div class="gmail_quote">On Sat, Jan 31, 2009 at 11:18 PM, Frank Freeman <span dir="ltr">&lt;<a href="mailto:ffreeman@...">ffreeman@...</a>&gt;</span> wrote:<br><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
unsubscribe<br>
<br>
</blockquote><div>Hmph.&nbsp; You can&#39;t get out that easy.<br><br><pre>Please Note:  In some later model unsubscribe kits, the &quot;OFF&quot; indicator has<br>been replaced by &quot;POWER-UP STANDBY ENABLE&quot;.  Accordingly the &quot;ON&quot; indicator<br>
has been replaced by the much clearer, &quot;POWER-DOWN STANDBY ENABLE&quot;.  Contact<br>your internet service provider for a list of affected model numbers.  An<br>&quot;ON-OFF&quot; retrofit panel kit is available for those who have difficulty with<br>
the new and much clearer labeling.<br></pre><br clear="all"><pre>First, ask your Internet Provider to mail you an Unsubscribing Kit. Then follow these <br>directions. The kit will most likely be the standard no-fault type. Depending on <br>
requirements, System A and/or System B can be used. When operating System A, depress <br>lever and a plastic dalkron unsubscriber will be dispensed through the slot <br>immediately underneath. When you have fastened the adhesive lip, attach connection <br>
marked by the large &quot;X&quot; outlet hose. Twist the silver- coloured ring one inch below <br>the connection point until you feel it lock.<br><br>The kit is now ready for use. The Cin-Eliminator is activated by the small switch on <br>
the lip. When securing, twist the ring back to its initial condition, so that the two <br>orange lines meet. Disconnect. Place the dalkron unsubscriber in the vacuum receptacle <br>to the rear. Activate by pressing the blue button.<br>
<br>The controls for System B are located on the opposite side. The red release switch <br>places the Cin-Eliminator into position; it can be adjusted manually up or down by <br>pressing the blue manual release button. The opening is self- adjusting. To secure <br>
after use, press the green button, which simultaneously activates the evaporator and <br>returns the Cin-Eliminator to its storage position.<br><br>You may log off if the green exit light is on over the evaporator . If the red light <br>
is illuminated, one of the Cin-Eliminator requirements has not been properly <br>implemented. Press the &quot;List Guy&quot; call button on the right of the evaporator . He will <br>secure all facilities from his control panel.<br>
<br>To use the Auto-Unsub, first undress and place all your clothes in the clothes rack. <br>Put on the velcro slippers located in the cabinet immediately below. Enter the shower, <br>taking the entire kit with you. On the control panel to your upper right upon entering <br>
you will see a &quot;Shower seal&quot; button. Press to activate. A green light will then be <br>illuminated immediately below. On the intensity knob, select the desired setting. Now <br>depress the Auto-Unsub activation lever. Bathe normally.<br>
<br>The Auto-Unsub will automatically go off after three minutes unless you activate the <br>&quot;Manual off&quot; override switch by flipping it up. When you are ready to leave, press the <br>blue &quot;Shower seal&quot; release button. The door will open and you may leave. Please remove <br>
the velcro slippers and place them in their container.<br><br>If you prefer the ultrasonic log-off mode, press the indicated blue button. When the <br>twin panels open, pull forward by rings A &amp; B. The knob to the left, just below the <br>
blue light, has three settings, low, medium or high. For normal use, the medium <br>setting is suggested.<br><br>After these settings have been made, you can activate the device by switching to the <br>&quot;ON&quot; position the clearly marked red switch. If during the unsubscribing operation, <br>
you wish to change the settings, place the &quot;manual off&quot; override switch in the &quot;OFF&quot; <br>position. You may now make the change and repeat the cycle. When the green exit light <br>goes on, you may log off and have lunch. Please close the door behind you.<br>
<br><br></pre>Harry Holt, PMP<br><br>&quot;Somebody has to do something, and it&#39;s just incredibly pathetic that it has to be us.&quot;<br> &nbsp;- Jerry Garcia<br>
<br>&nbsp;P.S.&nbsp; I&#39;ll go ahead and apologize now.&nbsp; It won&#39;t happen again.<br></div></div><br>
Replies:
Re: unsubscribe
-- Lindsay Haisley
References:
unsubscribe
-- Frank Freeman
Navigation:
Lists: gentoo-desktop: < Prev By Thread Next > < Prev By Date Next >
Previous by thread:
unsubscribe
Next by thread:
Re: unsubscribe
Previous by date:
unsubscribe
Next by date:
Re: unsubscribe


Updated Jun 17, 2009

Summary: Archive of the gentoo-desktop mailing list.

Donate to support our development efforts.

Copyright 2001-2013 Gentoo Foundation, Inc. Questions, Comments? Contact us.