esa wrote:
> Dear users, 
> 
> It's my first step to program a embedded system. 
> It's a industrial PC with a compact flash. On this compact flash, I put
> uclibc + busybox. 
> So, I think, it is not a cross-development.
> 
> Until now, I program on DOS system with a IDE like BORLAND CPP. 
> I think, it is not possible to use such IDE on linux under a terminal
> session ( so without using X, KDE, Gnome ). 
> 
> I read, that CODE::blocks is a good IDE. 
> My question : 
> - Do I install the GNOME, X Windows or KDE for using CODE::block ? What is
> the best ? 
> - For my target, I use uclibc. Must I install code block under my CHOST (
> where I install uclibc ). Or maybee it is not necessary. 
> - In this case, must I configure CODE::block to use uclibc ? 
> -Is it something important to configure in MAKE.CONF ? 
> - my target is a Industrial PC with a GEODE processor. 
> I know, it is a lot of questions 
> Is it a document, where I can find what I can use and how to configure ? 
> Thanks again for your help. 
> Regards 
> Eric


Hello Eric,


Here is an excellent place to start reading:


http://www.gentoo.org/proj/en/base/embedded/handbook/index.xml


hth,
James