Dear users, 

It's my first step to program a embedded system. 
It's a industrial PC with a compact flash. On this compact flash, I put
uclibc + busybox. 
So, I think, it is not a cross-development.

Until now, I program on DOS system with a IDE like BORLAND CPP. 
I think, it is not possible to use such IDE on linux under a terminal
session ( so without using X, KDE, Gnome ). 

I read, that CODE::blocks is a good IDE. 
My question : 
- Do I install the GNOME, X Windows or KDE for using CODE::block ? What is
the best ? 
- For my target, I use uclibc. Must I install code block under my CHOST (
where I install uclibc ). Or maybee it is not necessary. 
- In this case, must I configure CODE::block to use uclibc ? 
-Is it something important to configure in MAKE.CONF ? 
- my target is a Industrial PC with a GEODE processor. 
I know, it is a lot of questions 
Is it a document, where I can find what I can use and how to configure ? 
Thanks again for your help. 
Regards 
Eric
-- 
View this message in context: http://www.nabble.com/-embedded--first-step-in-programming-geode-target-tp22668975p22668975.html
Sent from the gentoo-embedded mailing list archive at Nabble.com.