Gentoo Logo
Gentoo Spaceship




Note: Due to technical difficulties, the Archives are currently not up to date. GMANE provides an alternative service for most mailing lists.
c.f. bug 424647
List Archive: gentoo-laptop
Navigation:
Lists: gentoo-laptop: < Prev By Thread Next > < Prev By Date Next >
Headers:
To: gentoo-laptop@g.o
From: it maxim <zuboskal14@...>
Subject: Wicd don't work with sky2
Date: Wed, 24 Mar 2010 21:07:25 +0300
Sorry, I forgot - it english list)

    I have НР probook 5310m with this ethernet card:
        03:00.0 Ethernet controller: Marvell Technology Group Ltd. Device 436c (rev 10)

Kernel 2.6.33, net-misc/wicd-1.7.0
        
    Sky2 is now compiled as a module, but I tried install it in kernel too.
    
    When I try connect to wired network with wicd it "getting IP address..." And as a result - "no connection".

    If I manual config IP wicd shows "connected", but network don't work in realty. 

    When I use ifconfig to rule wired connection, or just run "dhcpcd eth0" - all works fine.

    Any ideas?



Navigation:
Lists: gentoo-laptop: < Prev By Thread Next > < Prev By Date Next >
Previous by thread:
sky2 не работает с wicd
Next by thread:
tuxonice hibernation
Previous by date:
Re: [gentoo-laptop] sky2 не работает с wicd
Next by date:
tuxonice hibernation


Updated Jun 19, 2012

Summary: Archive of the gentoo-laptop mailing list.

Donate to support our development efforts.

Copyright 2001-2013 Gentoo Foundation, Inc. Questions, Comments? Contact us.