Kumba schrieb:

> I did hit the ldscripts error, which needed a fix in binutils-config.  
> But this ranlib-based one, I haven't hit in the last few times I've run 
> catalyst to build newer livecds.  All I can say, is use crossdev to 
> completely remove all traces of cross-compilers, then follow behind it 
> in /usr and remove any left overs that might be remaining (usually in 
> /usr/${CHOST}/*).  Then, remove all your kernel trees.

I did this and hopefully removed everything which looked like mips64.

> Remerge everything, using gcc-4.1.2 and binutils-2.17, and cross 
> fingers.  Make sure you're running "make vmlinux" for 64bit targets 
> (IP28, IP27, IP30) or vmlinux.32 for quasi-64bit targets (IP22, IP32).  
> Also make sure you have the latest crossdev too.

Now I emerged gcc-4.1.2 but then kgcc64-4.1.2 fails during compile:

rm -f include/limits.h
cp xlimits.h include/limits.h
cp /var/tmp/portage/sys-devel/kgcc64-4.1.2/work/gcc-4.1.2/gcc/unwind-generic.h include/unwind.h
chmod a+r include/limits.h
rm -f include/README
cp /var/tmp/portage/sys-devel/kgcc64-4.1.2/work/gcc-4.1.2/gcc/../fixincludes/README-fixinc include/README
chmod a+r include/README
echo timestamp > stmp-int-hdrs
make[2]: *** No rule to make target `/usr/bin/mips64-unknown-linux-gnu-as', needed by `stamp-as'.  Stop.
make[2]: Leaving directory `/var/tmp/portage/sys-devel/kgcc64-4.1.2/work/build/gcc'
make[1]: *** [all-gcc] Error 2
make[1]: Leaving directory `/var/tmp/portage/sys-devel/kgcc64-4.1.2/work/build'
make: *** [all] Error 2

!!! ERROR: sys-devel/kgcc64-4.1.2 failed.
Call stack:
   ebuild.sh, line 1615:   Called dyn_compile
   ebuild.sh, line 972:   Called qa_call 'src_compile'
   ebuild.sh, line 44:   Called src_compile
   ebuild.sh, line 1305:   Called toolchain_src_compile
   toolchain.eclass, line 26:   Called gcc_src_compile
   toolchain.eclass, line 1541:   Called gcc_do_make
   toolchain.eclass, line 1415:   Called die

!!! emake failed with all
!!! If you need support, post the topmost build error, and the call stack if relevant.
!!! A complete build log is located at '/var/tmp/portage/sys-devel/kgcc64-4.1.2/temp/build.log'.

----------------------------------------
Now I'm not sure if this may be in relation to the cleaning because I had kgcc64-4.1.1 before.
(I'm pretty sure that I did too much cleaning because kgcc64-4.1.1 shows the same error now)

I think I rebuild this machine from Scratch: is there a newer stage3 available than this: stage3-mips4-2006.0.tar.bz2 ?

-- 
Mathias Weigt



-- 
gentoo-mips@g.o mailing list