1 |
hello, |
2 |
I have installed Gentoo PPC (2005.1) on my 800 Mhz Titanium PowerBook |
3 |
G4 successfully (it boots). I have some problems, however, and I was |
4 |
wondering if anyone could help me. As it stands, I can not do the |
5 |
following which I would like: |
6 |
1) I cannot configure ethernet (on eth0) or airport (on eth1, wifi1, |
7 |
and wlan1). after running "alias eth0=sungem" and "alias eth1=airport", |
8 |
"alias wifi1=airport", and "alias wlan1=airport", I still cannot |
9 |
connect using net.eth0 and net.eth1, etc, config and ifup eth0/ifup |
10 |
eth1. It says (I am booted into OSX now because I cannot get mail from |
11 |
Gentoo, so this might be a little off): |
12 |
ifconfig: eth0: device not found |
13 |
or something like that. The same goes for eth1. Is there a guide |
14 |
somewhere that I could read about configuring ethernet and airport |
15 |
under gentoo? |
16 |
2) I have a problem with my kernel. When I try to boot off of a kernel |
17 |
that I complied myself, it always gives " returning 0x01400000 from |
18 |
prom_init" as an error in the Open Firmware white background, then NO |
19 |
MORE TEXT is outputted, and it freezes. Apparently, this error is |
20 |
common with powermac G5's (except with more text and a return to the OF |
21 |
prompt), but why my old powerbook has it I do not know. to compile the |
22 |
kernel, I ran |
23 |
make clean dep modules modules_install vmlinux |
24 |
dep was not needed. My system says making the vmlinux image worked |
25 |
fine. however, it does not boot, instead giving the above error. Any |
26 |
ideas on how I could get it to work? |
27 |
3) I cannot mount hfs+ filesystems. When I run |
28 |
mount /dev/hda13 /mnt/share |
29 |
or |
30 |
mount -t hfs /dev/hda13 /mnt/share |
31 |
it complains that it does not know what hfs is. What are the steps for |
32 |
mounting an hfs+ partition under linux? or should I just switch to UFS? |
33 |
4) This is a question about Mac-On-Linux. I was wondering how to |
34 |
install and run it. I have it installed, but when I run what it says to |
35 |
on the man pages, I get some errors about the display, and I think the |
36 |
OSX partition (I am really sorry I am so vague, but I forgot it since |
37 |
running MOL is not as high a priority right now as getting my linux |
38 |
system configured). It does the same thing when run in an xterm or |
39 |
Terminal Window (GNOME). |
40 |
5) How do I configure multiple virtual command lines and switch between |
41 |
them? I had it working at one point, but it no longer functions. initrc |
42 |
says all the spawn extra terminal commands, but I cannot switch between |
43 |
displays using any key commands I know of. |
44 |
|
45 |
I am pretty sure that most of these errors are due to not having a |
46 |
properly configured kernel, but there could be others as well. |
47 |
thanks in advance for any help, |
48 |
Nicholas |