[gentooppc-user] Kernel Panic on new install

[John Gilger]

I just did my first Gentoo install on my Ti PowerBook G4 from a TuxCDs 
stage1 cd. It only took a little over 6 hours, including an emerge of 
gcc because the source on the CD would not compile. I just followed the 
instructions and everything went quite smoothly. I had a mistake to 
clear up in yaboot.conf and /etc/fstab that prevented reboot while I was 
at work an hooked up to a T-1 line.

I fixed the config errors at home (just a dial-up) and when I tried to 
boot gentoo, I got a kernel panic right after the NET4: portion of the 
init process.

It said it wanted 33 and the limit=28 and something about over reaching 
and 03:03

The system rebooted before I could find a pencil and write down the 
correct error message.

Did the kernel panic because I wasn't connected to the 'net? Or????

TIA

John