1 |
> We are not doing bridging, no. I'd contemplate that the issues are with 32bit |
2 |
> interfaces not existing for it though. A solution would be to use a 64 bit |
3 |
> static brctl binary. I'll see if I still have a 64 bit userland around. |
4 |
how to make a 64bit static brctl binary at kernel 2.4.32? |
5 |
|
6 |
I can't compile the current bridge-utils with 2.4.x :( |
7 |
bye |
8 |
peter |
9 |
|
10 |
> |
11 |
> Josh |
12 |
> |
13 |
> |
14 |
> NADASI Peter wrote: |
15 |
> >>We see the same problems with the V240 (same board, different case). Dave Miller |
16 |
> >>(the linux sparc kernel maintainer) does not have access to a similar box, so at |
17 |
> >>this point, Send Patches. We are having good luck with 2.4.32 except for a few |
18 |
> >>minor issues. |
19 |
> > |
20 |
> > and can you make ethernet bridging with 2.4.3x ? |
21 |
> > i compiled my kernel with the bridge support, downloaded the |
22 |
> > bridge-utils v1.0.6 and it requires the 2.6.x series kernel headers :((( |
23 |
> > since bridge-utils 1.x the 2.6.x kernel is needed... i think. |
24 |
> > older 0.9.7 versions are compiled fine but i get this message: |
25 |
> > |
26 |
> > #./brctl addbr bri |
27 |
> > Get bridge indices failed: Operation not supported |
28 |
> > can't setup bridge control: Operation not supported |
29 |
> > |
30 |
> > if I compile it in module, i get the same :( |
31 |
> > |
32 |
> > has anyone experience using bridge in 2.4.x? |
33 |
> > Peter |
34 |
> > |
35 |
> > |
36 |
> >>>I'm running a SUN v210 with 2.4.32 fine but I have to make an ethernet |
37 |
> >>>bridge and bridge-utils requires 2.6.x |
38 |
> >>>I have compiled a lot of 2.6.x kernels, with udev, with devfs, etc.. but |
39 |
> >>>everytime if the 2.6.x is booting, it freezes at: |
40 |
> >>> |
41 |
> >>>VFS: Mounted root (ext3 filesystem) readonly. |
42 |
> >>> |
43 |
> >>>I don't see the usual INIT message, it doesn't start the boot runlevel. |
44 |
> >>>It freezes very serious, I can reboot it only after a power-off. |
45 |
> >>> |
46 |
> >>>But if I boot with the 2.4.32 then it works pretty well!!! |
47 |
> >>> |
48 |
> >>>Have you met this problem earlier? |
49 |
> >>>Any hints, ideas are welcome! |
50 |
> >>>Best Regards, |
51 |
> >>>Peter |
52 |
> >>> |
53 |
> >> |
54 |
> |
55 |
-- |
56 |
gentoo-sparc@g.o mailing list |