| 1 |
I got the system installed, and everything seems to be okay with three |
| 2 |
exceptions: |
| 3 |
|
| 4 |
1) I have to run "boot disk1:1" at the PROM prompt to get the system to |
| 5 |
boot. I assume I can set that into the PROM, just like I set the cdrom |
| 6 |
to be what is boot, no? If not, how do I resolve that? FYI - In case it |
| 7 |
matters, I did accidentally delete the #3 partition during the |
| 8 |
partitioning, but recreated it using the 's' command in fdisk. |
| 9 |
|
| 10 |
2) Just before #3 happens, I notice a message from the kernel stating it |
| 11 |
can't find the initrd image located in /boot - generated by genkernel. I |
| 12 |
didn't setup a _separate_ boot partition, but that shouldn't be an issue |
| 13 |
for SILO should it? |
| 14 |
|
| 15 |
3) The system loads the kernel, which runs a little, then switches vid |
| 16 |
modes and blanks - it doesn't return to the screen like the 2007.0 2617 |
| 17 |
does when the atyfb is not disabled, it just blanks, and dies per #2. |
| 18 |
Using 'video=atyfb:off' resolves this and reveals the messages. I'd |
| 19 |
really like to be able to not have to use 'atyfb:off' as it really hurts |
| 20 |
the eyes the way it reprints the screen all the time for the littlest |
| 21 |
line movement. Any recommendations? (I could live with it if I |
| 22 |
absolutely had to.) |
| 23 |
|
| 24 |
FYI - after #3 the system completely hangs, and despite the message |
| 25 |
about STOP+A, it doesn't work until I completely cycle the power the |
| 26 |
system - no return to the PROM; the soft-power button _does_ work for this. |
| 27 |
|
| 28 |
TIA, |
| 29 |
|
| 30 |
Ben |
| 31 |
|
| 32 |
-- |
| 33 |
gentoo-sparc@l.g.o mailing list |
Archives