| 1 |
> -----Original Message----- |
| 2 |
> From: Daevid Vincent [mailto:daevid@××××××.com] |
| 3 |
> Sent: 21 December 2006 10:11 |
| 4 |
> To: gentoo-user@l.g.o |
| 5 |
> Subject: [gentoo-user] Help getting PCMCIA WiFi card working again |
| 6 |
|
| 7 |
--snipsnip-- |
| 8 |
|
| 9 |
> daevid ~ # ifconfig |
| 10 |
> eth0 Link encap:Ethernet HWaddr 00:03:47:3B:65:87 |
| 11 |
> inet addr:24.17.255.202 Bcast:255.255.255.255 |
| 12 |
> Mask:255.255.252.0 |
| 13 |
> UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 |
| 14 |
> Metric:1 |
| 15 |
> RX packets:5739 errors:0 dropped:0 overruns:0 frame:0 |
| 16 |
> TX packets:150 errors:0 dropped:0 overruns:0 carrier:0 |
| 17 |
> collisions:0 txqueuelen:1000 |
| 18 |
> RX bytes:363967 (355.4 Kb) TX bytes:35779 (34.9 Kb) |
| 19 |
> |
| 20 |
> eth1 Link encap:Ethernet HWaddr 00:03:47:3B:65:88 |
| 21 |
> inet addr:192.168.1.1 Bcast:192.168.1.255 |
| 22 |
> Mask:255.255.255.0 |
| 23 |
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 |
| 24 |
> RX packets:27 errors:0 dropped:0 overruns:0 frame:0 |
| 25 |
> TX packets:50 errors:0 dropped:0 overruns:0 carrier:0 |
| 26 |
> collisions:0 txqueuelen:1000 |
| 27 |
> RX bytes:4112 (4.0 Kb) TX bytes:7001 (6.8 Kb) |
| 28 |
> |
| 29 |
> lo Link encap:Local Loopback |
| 30 |
> inet addr:127.0.0.1 Mask:255.0.0.0 |
| 31 |
> UP LOOPBACK RUNNING MTU:16436 Metric:1 |
| 32 |
> RX packets:12 errors:0 dropped:0 overruns:0 frame:0 |
| 33 |
> TX packets:12 errors:0 dropped:0 overruns:0 carrier:0 |
| 34 |
> collisions:0 txqueuelen:0 |
| 35 |
> RX bytes:1096 (1.0 Kb) TX bytes:1096 (1.0 Kb) |
| 36 |
> |
| 37 |
> |
| 38 |
> daevid ~ # iwconfig |
| 39 |
> eth0 no wireless extensions. |
| 40 |
> |
| 41 |
> eth1 no wireless extensions. |
| 42 |
> |
| 43 |
> lo no wireless extensions. |
| 44 |
> |
| 45 |
> wifi0 IEEE 802.11b ESSID:"test" |
| 46 |
> Mode:Master Access Point: Not-Associated Bit Rate:11 Mb/s |
| 47 |
> Sensitivity=1/3 |
| 48 |
> Retry min limit:8 RTS thr:off Fragment thr:off |
| 49 |
> Encryption key:off |
| 50 |
> Power Management:off |
| 51 |
> |
| 52 |
> wlan0ap IEEE 802.11b ESSID:"test" |
| 53 |
> Mode:Master Access Point: Not-Associated Bit Rate:11 Mb/s |
| 54 |
> Sensitivity=1/3 |
| 55 |
> Retry min limit:8 RTS thr:off Fragment thr:off |
| 56 |
> Encryption key:off |
| 57 |
> Power Management:off |
| 58 |
> Link Quality:0 Signal level:0 Noise level:0 |
| 59 |
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 |
| 60 |
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0 |
| 61 |
> |
| 62 |
|
| 63 |
Forgive me if I am mistaken, but doesn't this show your WLAN card not |
| 64 |
being called wlan0, but instead being called wifi0? |
| 65 |
|
| 66 |
Just a guess. |
| 67 |
|
| 68 |
David |
| 69 |
|
| 70 |
Note: These views are my own, advice is provided with no guarantee of |
| 71 |
success. I do not represent anyone else in any emails I send to this |
| 72 |
list. |
| 73 |
|
| 74 |
-- |
| 75 |
gentoo-user@g.o mailing list |
Archives