1 |
pecan bery wrote: |
2 |
> |
3 |
> |
4 |
> |
5 |
> unsubscribe yetties_eat_gays@×××××××.com |
6 |
> <mailto:yetties_eat_gays@×××××××.com> |
7 |
> |
8 |
> |
9 |
> ------------------------------------------------------------------------ |
10 |
> New year, new job – there's more than 100,00 jobs at SEEK |
11 |
> <http://g.msn.com/8HMAENAU/2740??PS=47575> -- gentoo-amd64@g.o |
12 |
> mailing list |
13 |
|
14 |
Here's how to unsubscribe: |
15 |
|
16 |
First, ask your Internet Provider to mail you an Unsubscribing Kit. |
17 |
Then follow these directions. |
18 |
|
19 |
The kit will most likely be the standard no-fault type. Depending on |
20 |
requirements, System A and/or System B can be used. When operating |
21 |
System A, depress lever and a plastic dalkron unsubscriber will be |
22 |
dispensed through the slot immediately underneath. When you have |
23 |
fastened the adhesive lip, attach connection marked by the large "X" |
24 |
outlet hose. Twist the silver-coloured ring one inch below the |
25 |
connection point until you feel it lock. |
26 |
|
27 |
The kit is now ready for use. The Cin-Eliminator is activated by the |
28 |
small switch on the lip. When securing, twist the ring back to its |
29 |
initial condition, so that the two orange lines meet. Disconnect. |
30 |
Place the dalkron unsubscriber in the vacuum receptacle to the rear. |
31 |
Activate by pressing the blue button. |
32 |
|
33 |
The controls for System B are located on the opposite side. The red |
34 |
release switch places the Cin-Eliminator into position; it can be |
35 |
adjusted manually up or down by pressing the blue manual release |
36 |
button. The opening is self-adjusting. To secure after use, press the |
37 |
green button, which simultaneously activates the evaporator and |
38 |
returns the Cin-Eliminator to its storage position. |
39 |
|
40 |
You may log off if the green exit light is on over the evaporator. If |
41 |
the red light is illuminated, one of the Cin-Eliminator requirements |
42 |
has not been properly implemented. Press the "List Guy" call button on |
43 |
the right of the evaporator. He will secure all facilities from his |
44 |
control panel. |
45 |
|
46 |
To use the Auto-Unsub, first undress and place all your clothes in the |
47 |
clothes rack. Put on the velcro slippers located in the cabinet |
48 |
immediately below. Enter the shower, taking the entire kit with |
49 |
you. On the control panel to your upper right upon entering you will |
50 |
see a "Shower seal" button. Press to activate. A green light will then |
51 |
be illuminated immediately below. On the intensity knob, select the |
52 |
desired setting. Now depress the Auto-Unsub activation lever. Bathe |
53 |
normally. |
54 |
|
55 |
The Auto-Unsub will automatically go off after three minutes unless |
56 |
you activate the "Manual off" override switch by flipping it up. When |
57 |
you are ready to leave, press the blue "Shower seal" release |
58 |
button. The door will open and you may leave. Please remove the velcro |
59 |
slippers and place them in their container. |
60 |
|
61 |
If you prefer the ultrasonic log-off mode, press the indicated blue |
62 |
button. When the twin panels open, pull forward by rings A & B. The |
63 |
knob to the left, just below the blue light, has three settings, low, |
64 |
medium or high. For normal use, the medium setting is suggested. |
65 |
|
66 |
After these settings have been made, you can activate the device by |
67 |
switching to the "ON" position the clearly marked red switch. If |
68 |
during the unsubscribing operation you wish to change the settings, |
69 |
place the "manual off" override switch in the "OFF" position. You may |
70 |
now make the change and repeat the cycle. When the green exit light |
71 |
goes on, you may log off and have lunch. Please close the door behind |
72 |
you. |
73 |
|
74 |
-- |
75 |
gentoo-amd64@g.o mailing list |