1 |
Here's how to unsubscribe: |
2 |
|
3 |
First, ask your Internet Provider to mail you an Unsubscribing Kit. |
4 |
Then follow these directions. |
5 |
|
6 |
The kit will most likely be the standard no-fault type. Depending on |
7 |
requirements, System A and/or System B can be used. When operating |
8 |
System A, depress lever and a plastic dalkron unsubscriber will be |
9 |
dispensed through the slot immediately underneath. When you have |
10 |
fastened the adhesive lip, attach connection marked by the large "X" |
11 |
outlet hose. Twist the silver-coloured ring one inch below the |
12 |
connection point until you feel it lock. |
13 |
|
14 |
The kit is now ready for use. The Cin-Eliminator is activated by the |
15 |
small switch on the lip. When securing, twist the ring back to its |
16 |
initial condition, so that the two orange lines meet. Disconnect. |
17 |
Place the dalkron unsubscriber in the vacuum receptacle to the rear. |
18 |
Activate by pressing the blue button. |
19 |
|
20 |
The controls for System B are located on the opposite side. The red |
21 |
release switch places the Cin-Eliminator into position; it can be |
22 |
adjusted manually up or down by pressing the blue manual release button. |
23 |
The opening is self-adjusting. To secure after use, press the green |
24 |
button, which simultaneously activates the evaporator and returns the |
25 |
Cin-Eliminator to its storage position. |
26 |
|
27 |
You may log off if the green exit light is on over the evaporator. If |
28 |
the red light is illuminated, one of the Cin-Eliminator requirements has |
29 |
not been properly implemented. Press the "List Guy" call button on the |
30 |
right of the evaporator. He will secure all facilities from his control |
31 |
panel. |
32 |
|
33 |
To use the Auto-Unsub, first undress and place all your clothes in the |
34 |
clothes rack. Put on the velcro slippers located in the cabinet |
35 |
immediately below. Enter the shower, taking the entire kit with you. On |
36 |
the control panel to your upper right upon entering you will see a |
37 |
"Shower seal" button. Press to activate. A green light will then be |
38 |
illuminated immediately below. On the intensity knob, select the desired |
39 |
setting. Now depress the Auto-Unsub activation lever. Bathe normally. |
40 |
|
41 |
The Auto-Unsub will automatically go off after three minutes unless you |
42 |
activate the "Manual off" override switch by flipping it up. When you |
43 |
are ready to leave, press the blue "Shower seal" release button. The |
44 |
door will open and you may leave. Please remove the velcro slippers and |
45 |
place them in their container. |
46 |
|
47 |
If you prefer the ultrasonic log-off mode, press the indicated blue |
48 |
button. When the twin panels open, pull forward by rings A & B. The knob |
49 |
to the left, just below the blue light, has three settings, low, medium |
50 |
or high. For normal use, the medium setting is suggested. |
51 |
|
52 |
After these settings have been made, you can activate the device by |
53 |
switching to the "ON" position the clearly marked red switch. If during |
54 |
the unsubscribing operation you wish to change the settings, place the |
55 |
"manual off" override switch in the "OFF" position. You may now make the |
56 |
change and repeat the cycle. When the green exit light goes on, you may |
57 |
log off and have lunch. Please close the door behind you. |
58 |
-- |
59 |
gentoo-amd64@g.o mailing list |