Gentoo Archives: gentoo-amd64

From: felix@×××××××.com
To: gentoo-amd64@l.g.o
Subject: Re: [gentoo-amd64] unsubscribe
Date: Fri, 22 Aug 2008 14:08:03
Message-Id: 20080822140754.GA28666@crowfix.com
In Reply to: [gentoo-amd64] unsubscribe by Daniele Salatti
1 On Fri, Aug 22, 2008 at 03:24:41PM +0200, Daniele Salatti wrote:
2 >
3
4 Well, cat's got your tongue, I see, so I will step boldy into the
5 void.
6
7 Here's how to unsubscribe:
8
9 First, ask your Internet Provider to mail you an Unsubscribing Kit.
10 Then follow these directions.
11
12 The kit will most likely be the standard no-fault type. Depending on
13 requirements, System A and/or System B can be used. When operating
14 System A, depress lever and a plastic dalkron unsubscriber will be
15 dispensed through the slot immediately underneath. When you have
16 fastened the adhesive lip, attach connection marked by the large "X"
17 outlet hose. Twist the silver-coloured ring one inch below the
18 connection point until you feel it lock.
19
20 The kit is now ready for use. The Cin-Eliminator is activated by the
21 small switch on the lip. When securing, twist the ring back to its
22 initial condition, so that the two orange lines meet. Disconnect.
23 Place the dalkron unsubscriber in the vacuum receptacle to the rear.
24 Activate by pressing the blue button.
25
26 The controls for System B are located on the opposite side. The red
27 release switch places the Cin-Eliminator into position; it can be
28 adjusted manually up or down by pressing the blue manual release
29 button. The opening is self-adjusting. To secure after use, press the
30 green button, which simultaneously activates the evaporator and
31 returns the Cin-Eliminator to its storage position.
32
33 You may log off if the green exit light is on over the evaporator. If
34 the red light is illuminated, one of the Cin-Eliminator requirements
35 has not been properly implemented. Press the "List Guy" call button on
36 the right of the evaporator. He will secure all facilities from his
37 control panel.
38
39 To use the Auto-Unsub, first undress and place all your clothes in the
40 clothes rack. Put on the velcro slippers located in the cabinet
41 immediately below. Enter the shower, taking the entire kit with
42 you. On the control panel to your upper right upon entering you will
43 see a "Shower seal" button. Press to activate. A green light will then
44 be illuminated immediately below. On the intensity knob, select the
45 desired setting. Now depress the Auto-Unsub activation lever. Bathe
46 normally.
47
48 The Auto-Unsub will automatically go off after three minutes unless
49 you activate the "Manual off" override switch by flipping it up. When
50 you are ready to leave, press the blue "Shower seal" release
51 button. The door will open and you may leave. Please remove the velcro
52 slippers and place them in their container.
53
54 If you prefer the ultrasonic log-off mode, press the indicated blue
55 button. When the twin panels open, pull forward by rings A & B. The
56 knob to the left, just below the blue light, has three settings, low,
57 medium or high. For normal use, the medium setting is suggested.
58
59 After these settings have been made, you can activate the device by
60 switching to the "ON" position the clearly marked red switch. If
61 during the unsubscribing operation you wish to change the settings,
62 place the "manual off" override switch in the "OFF" position. You may
63 now make the change and repeat the cycle. When the green exit light
64 goes on, you may log off and have lunch. Please close the door behind
65 you.
66
67
68 --
69 ... _._. ._ ._. . _._. ._. ___ .__ ._. . .__. ._ .. ._.
70 Felix Finch: scarecrow repairman & rocket surgeon / felix@×××××××.com
71 GPG = E987 4493 C860 246C 3B1E 6477 7838 76E9 182E 8151 ITAR license #4933
72 I've found a solution to Fermat's Last Theorem but I see I've run out of room o

Replies

Subject Author
Re: [gentoo-amd64] unsubscribe Daniele Salatti <danielesalatti@×××××.com>