| 1 |
I found my way through! |
| 2 |
|
| 3 |
I should have waited before mailing, sorry for the waste of your time. |
| 4 |
|
| 5 |
Regards all |
| 6 |
|
| 7 |
Erick |
| 8 |
|
| 9 |
On 3/15/06, Erick Michau <balkira@×××××.com> wrote: |
| 10 |
> |
| 11 |
> hi all, |
| 12 |
> |
| 13 |
> I am using catalyst-2.0-rc40 on an x86 with a 2006.0 stage3 as a seed |
| 14 |
> stage. |
| 15 |
> I am doing a livecd booting directly on xorg-x11 so I have successfully |
| 16 |
> achieved: |
| 17 |
> # catalyst2 -f livecd-stage1_template.spec |
| 18 |
> # catalyst2 -f livecd-stage2_template.spec |
| 19 |
> Here is the content of fsscript.sh: |
| 20 |
> echo "/etc/init.d/mkxf86config start" >> /etc/conf.d/local.start |
| 21 |
> echo "/etc/init.d/x-setup start" >> |
| 22 |
> /etc/conf.d/local.start |
| 23 |
> echo "startx" >> |
| 24 |
> /etc/conf.d/local.start |
| 25 |
> However, xorg breaks at startup and I found that the "speedo" module was |
| 26 |
> the cause so I deleted it from xorg.conf and "startx" works. |
| 27 |
> |
| 28 |
> I was wondering if it is possible to pass some parameters to the xorg.conffile for when |
| 29 |
> "/etc/init.d/mkxf86config start" is called in a different way than |
| 30 |
> customizing the "/usr/sbin/mkxf86config.sh" file by hand? |
| 31 |
> |
| 32 |
> In my case I do not want that "speedo" module to be loaded (X breaks). |
| 33 |
> Right now I am trying to adapt the "/usr/sbin/mkxf86config.sh" script to |
| 34 |
> rebuild xorg.conf _without_ the "speedo" module and it is painful..so I am |
| 35 |
> looking for an other way. |
| 36 |
> |
| 37 |
> If any ideas pop up I would be glade to hear it, |
| 38 |
> |
| 39 |
> Thanks by advance |
| 40 |
> |
| 41 |
> Erick |
| 42 |
> |
| 43 |
> |
| 44 |
> |
| 45 |
> |
| 46 |
> |
Archives