| 1 |
> We see the same problems with the V240 (same board, different case). Dave Miller |
| 2 |
> (the linux sparc kernel maintainer) does not have access to a similar box, so at |
| 3 |
> this point, Send Patches. We are having good luck with 2.4.32 except for a few |
| 4 |
> minor issues. |
| 5 |
and can you make ethernet bridging with 2.4.3x ? |
| 6 |
i compiled my kernel with the bridge support, downloaded the |
| 7 |
bridge-utils v1.0.6 and it requires the 2.6.x series kernel headers :((( |
| 8 |
since bridge-utils 1.x the 2.6.x kernel is needed... i think. |
| 9 |
older 0.9.7 versions are compiled fine but i get this message: |
| 10 |
|
| 11 |
#./brctl addbr bri |
| 12 |
Get bridge indices failed: Operation not supported |
| 13 |
can't setup bridge control: Operation not supported |
| 14 |
|
| 15 |
if I compile it in module, i get the same :( |
| 16 |
|
| 17 |
has anyone experience using bridge in 2.4.x? |
| 18 |
Peter |
| 19 |
|
| 20 |
> > I'm running a SUN v210 with 2.4.32 fine but I have to make an ethernet |
| 21 |
> > bridge and bridge-utils requires 2.6.x |
| 22 |
> > I have compiled a lot of 2.6.x kernels, with udev, with devfs, etc.. but |
| 23 |
> > everytime if the 2.6.x is booting, it freezes at: |
| 24 |
> > |
| 25 |
> > VFS: Mounted root (ext3 filesystem) readonly. |
| 26 |
> > |
| 27 |
> > I don't see the usual INIT message, it doesn't start the boot runlevel. |
| 28 |
> > It freezes very serious, I can reboot it only after a power-off. |
| 29 |
> > |
| 30 |
> > But if I boot with the 2.4.32 then it works pretty well!!! |
| 31 |
> > |
| 32 |
> > Have you met this problem earlier? |
| 33 |
> > Any hints, ideas are welcome! |
| 34 |
> > Best Regards, |
| 35 |
> > Peter |
| 36 |
> > |
| 37 |
> |
| 38 |
-- |
| 39 |
gentoo-sparc@g.o mailing list |
Archives