| 1 |
Hi Jürgen, |
| 2 |
|
| 3 |
mache gerade ein world update, als ich auf unten stehendes stieß, eventuell ist das ein Hinweis, ansonsten weiß ich's auch nicht... |
| 4 |
|
| 5 |
Good luck, Andy. |
| 6 |
|
| 7 |
|
| 8 |
Installing sys-fs/udev-135-r2 |
| 9 |
* |
| 10 |
* Updating persistent-net rules file |
| 11 |
* |
| 12 |
* restarting udevd now. |
| 13 |
* |
| 14 |
* persistent-net does assigning fixed names to network devices. |
| 15 |
* If you have problems with the persistent-net rules, |
| 16 |
* just delete the rules file |
| 17 |
* rm /etc/udev/rules.d/70-persistent-net.rules |
| 18 |
* and then reboot. |
| 19 |
* |
| 20 |
* This may however number your devices in a different way than they are now. |
| 21 |
* |
| 22 |
* If you build an initramfs including udev, then please |
| 23 |
* make sure that the /sbin/udevadm binary gets included, |
| 24 |
* and your scripts changed to use it,as it replaces the |
| 25 |
* old helper apps udevinfo, udevtrigger, ... |
| 26 |
* |
| 27 |
* mount options for directory /dev are no longer |
| 28 |
* set in /etc/udev/udev.conf, but in /etc/fstab |
| 29 |
* as for other directories. |
| 30 |
* |
| 31 |
* For more information on udev on Gentoo, writing udev rules, and |
| 32 |
* fixing known issues visit: |
| 33 |
* http://www.gentoo.org/doc/en/udev-guide.xml |
| 34 |
|
| 35 |
Am Monday 22 December 2008 19:12:23 schrieb Juergen Rose: |
| 36 |
> Hallo, |
| 37 |
> |
| 38 |
> ich habe hier einen Thinkpad T43 mit einem Atheros AR5212 Chip und einen |
| 39 |
> Thinkpad T61 mit einem Intel PRO/Wireless 4965 Chip. Fuer den Atheros |
| 40 |
> Chip benutze ich den madwifi-ng- und fuer den Intel Chip den |
| 41 |
> iwlagn-iwlwifi-4965-2.ucode-Treiber. |
| 42 |
> |
| 43 |
> Seit gestern gelingt es mir mit beiden Rechnern nicht mehr statische |
| 44 |
> IP-Adresse innerhalb von /etc/conf.d/net zu setzen. Beim T61 habe ich |
| 45 |
> z.B. in /etc/conf.d/net die folgenden Eintraege: |
| 46 |
> |
| 47 |
> config_wlan0="192.168.1.33 broadcast 192.168.1.255 netmask |
| 48 |
> 255.255.255.0" |
| 49 |
> routes_wlan0="default via 192.168.1.251" |
| 50 |
> modules="wpa_supplicant" |
| 51 |
> wpa_supplicant_eth0="-Dwext" # For generic wireless |
| 52 |
> |
| 53 |
> In /etc/wpa_supplicant/wpa_supplicant.conf steht: |
| 54 |
> eapol_version=1 |
| 55 |
> ap_scan=3 |
| 56 |
> network={ |
| 57 |
> ssid="jrnet" |
| 58 |
> key_mgmt=WPA-PSK |
| 59 |
> proto=WPA |
| 60 |
> pairwise=TKIP |
| 61 |
> group=TKIP |
| 62 |
> psk="PrivatPSK" |
| 63 |
> } |
| 64 |
> |
| 65 |
> Lsmod zeigt mir an das iwlagn und iwlcore geladen sind. Ifconfig macht |
| 66 |
> die folgenden Ausgaben: |
| 67 |
> |
| 68 |
> eth0 Link encap:Ethernet HWaddr 00:1e:37:cc:83:a9 |
| 69 |
> UP BROADCAST MULTICAST MTU:1500 Metric:1 |
| 70 |
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 |
| 71 |
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 |
| 72 |
> collisions:0 txqueuelen:1000 |
| 73 |
> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) |
| 74 |
> Memory:fe200000-fe220000 |
| 75 |
> |
| 76 |
> lo Link encap:Local Loopback |
| 77 |
> inet addr:127.0.0.1 Mask:255.0.0.0 |
| 78 |
> inet6 addr: ::1/128 Scope:Host |
| 79 |
> UP LOOPBACK RUNNING MTU:16436 Metric:1 |
| 80 |
> RX packets:62 errors:0 dropped:0 overruns:0 frame:0 |
| 81 |
> TX packets:62 errors:0 dropped:0 overruns:0 carrier:0 |
| 82 |
> collisions:0 txqueuelen:0 |
| 83 |
> RX bytes:4772 (4.6 KiB) TX bytes:4772 (4.6 KiB) |
| 84 |
> |
| 85 |
> wlan0 Link encap:Ethernet HWaddr 00:1f:3b:47:28:19 |
| 86 |
> inet6 addr: fe80::21f:3bff:fe47:2819/64 Scope:Link |
| 87 |
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 |
| 88 |
> RX packets:20 errors:0 dropped:0 overruns:0 frame:0 |
| 89 |
> TX packets:9 errors:0 dropped:0 overruns:0 carrier:0 |
| 90 |
> collisions:0 txqueuelen:1000 |
| 91 |
> RX bytes:5843 (5.7 KiB) TX bytes:993 (993.0 B) |
| 92 |
> |
| 93 |
> wmaster0 Link encap:UNSPEC HWaddr |
| 94 |
> 00-1F-3B-47-28-19-00-00-00-00-00-00-00-00-00-00 |
| 95 |
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 |
| 96 |
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 |
| 97 |
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 |
| 98 |
> collisions:0 txqueuelen:1000 |
| 99 |
> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) |
| 100 |
> |
| 101 |
> D.h., dem Interface wlan0 wurde nicht die IP-Adresse 192.168.1.33 |
| 102 |
> zugeordnet. iwconfig zeigt mir: |
| 103 |
> |
| 104 |
> lo no wireless extensions. |
| 105 |
> |
| 106 |
> sit0 no wireless extensions. |
| 107 |
> |
| 108 |
> eth0 no wireless extensions. |
| 109 |
> |
| 110 |
> wmaster0 no wireless extensions. |
| 111 |
> |
| 112 |
> pan0 no wireless extensions. |
| 113 |
> |
| 114 |
> wlan0 IEEE 802.11abgn ESSID:"jrnet" |
| 115 |
> Mode:Managed Frequency:2.462 GHz Access Point: |
| 116 |
> 00:14:BF:E1:DA:8B |
| 117 |
> Bit Rate=54 Mb/s Tx-Power=15 dBm |
| 118 |
> Retry min limit:7 RTS thr:off Fragment thr=2352 B |
| 119 |
> Encryption key:ALongHexKey Security mode:open |
| 120 |
> Power Management:off |
| 121 |
> Link Quality=100/100 Signal level:-32 dBm Noise level=-87 |
| 122 |
> dBm |
| 123 |
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 |
| 124 |
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0 |
| 125 |
> an. Wenn ich noch '/etc/init.d/net.wlan0 restart' eingebe, sehe ich: |
| 126 |
> |
| 127 |
> * Bringing down interface wlan0 |
| 128 |
> * Loaded modules: ip6to4 dhcpcd udhcpc dhclient system pppd iproute2 |
| 129 |
> ifconfig ssidnet wpa_supplicant iwconfig ipppd ifplugd netplugd macnet |
| 130 |
> macchanger ccwgroup bridge tuntap br2684ctl bonding arping apipa |
| 131 |
> * Stopping wpa_cli on wlan0... |
| 132 |
> * Will stop /usr/bin/wpa_cli |
| 133 |
> * Will stop PID in pidfile `/var/run/wpa_cli-wlan0.pid' |
| 134 |
> * Will stop processes of `/usr/bin/wpa_cli' |
| 135 |
> * Sending signal 15 to PID 21506... [ ok ] |
| 136 |
> [ ok ] |
| 137 |
> * Stopping wpa_supplicant on wlan0... |
| 138 |
> * Will stop /usr/sbin/wpa_supplicant |
| 139 |
> * Will stop PID in pidfile `/var/run/wpa_supplicant-wlan0.pid' |
| 140 |
> * Will stop processes of `/usr/sbin/wpa_supplicant' |
| 141 |
> * Sending signal 15 to PID 21499... [ ok ] |
| 142 |
> [ ok ] |
| 143 |
> * Bringing up interface wlan0 |
| 144 |
> * Loaded modules: apipa arping bonding tuntap bridge ccwgroup |
| 145 |
> macchanger macnet ifplugd wpa_supplicant ssidnet iproute2 pppd system |
| 146 |
> dhcpcd ip6to4 |
| 147 |
> * Configuring wlan0 for MAC address 00:1F:3B:47:28:19... [ ok ] |
| 148 |
> * ifplugd does not work with wireless |
| 149 |
> * Starting wpa_supplicant on wlan0... |
| 150 |
> * Detaching to start `/usr/sbin/wpa_supplicant'... [ ok ] |
| 151 |
> * Starting wpa_cli on wlan0... |
| 152 |
> * Detaching to start `/usr/bin/wpa_cli'... [ ok ] |
| 153 |
> * Backgrounding ......* WARNING: net.wlan0 has started, but is |
| 154 |
> inactive . |
| 155 |
> |
| 156 |
> Wenn ich versuche das wlan0-Interface manuell zu konfigurieren: |
| 157 |
> |
| 158 |
> ifconfig wlan0 192.168.1.33 |
| 159 |
> |
| 160 |
> funktioniert das und ich kann das Interface benutzen. Beim T43 sind die |
| 161 |
> Symptome vergleichbar, man muss nur wlan0 durch ath0 ersetzen. |
| 162 |
> Hat jemand eine Idee, was die Ursache ist? Kann openrc-0.4.0 die Ursache |
| 163 |
> sein? Wie loest man das Problem am besten? |
| 164 |
> |
| 165 |
> |
| 166 |
> |
| 167 |
> |
| 168 |
> |
| 169 |
> |
| 170 |
> |
| 171 |
> |
| 172 |
> |
| 173 |
> |
| 174 |
> |
Archives