| 1 |
Jean-Marc Beaune wrote: |
| 2 |
> Hi, |
| 3 |
> |
| 4 |
> According to your "restart" output, net.eth0 sarts at boot runlevel, |
| 5 |
> it should start at default runlevel. Check this with 'rc-update -s' |
| 6 |
> |
| 7 |
> If it really starts during boot runlevel, try the following : |
| 8 |
> |
| 9 |
> > rc-update del net.eth0 |
| 10 |
> > rc-update add net.eth0 default |
| 11 |
> |
| 12 |
> Then restart the system. |
| 13 |
Actually net.eth0 was installed in both runlevels. |
| 14 |
I did: |
| 15 |
rc-update -d net.eth0 |
| 16 |
rc-update -a net.eth0 default |
| 17 |
reboot |
| 18 |
|
| 19 |
The result is the same - the same output from "net.eth0 restart" and the |
| 20 |
interface is inactive until I manually give it IP addresses, bring it up |
| 21 |
and set a default route using the "ip" command from iproute2 package. |
| 22 |
|
| 23 |
In a few words: the problem is still here ;-( |
| 24 |
|
| 25 |
-- |
| 26 |
Best regards, |
| 27 |
Daniel |
| 28 |
|
| 29 |
|
| 30 |
-- |
| 31 |
gentoo-user@g.o mailing list |
Archives