1 |
On Fri, Mar 27, 2009 at 1:17 PM, Harry Putnam <reader@×××××××.com> wrote: |
2 |
> Boot partition is not involved here. Its on a a different (IDE) disk. |
3 |
> |
4 |
> Its not on a partition actually but in the MBR of Master drive on |
5 |
> first IDE controller. The newly added disk is sata and is on a PCI |
6 |
> sata controller (Adeptec 1205sa). |
7 |
|
8 |
After re-reading your first post, my guess would be: your new drives |
9 |
are SATA II but your Adapter controller does not support that, |
10 |
according to http://www.adaptec.com/en-US/support/sata/sata_host/ASH-1205SA/ |
11 |
|
12 |
Most drives have a jumper to put them into 1.5gbps mode (rather than |
13 |
3gbps mode). See if your new drives have one of those jumpers. |