1 |
On 25.02.2015 14:18, Bob Wya wrote: |
2 |
|
3 |
> Just out of interest what make is the Host Controller on your |
4 |
> motherboard... Is it a Intel one? Or some crappy addon chipset? Perhaps you |
5 |
> could post the output of lscpi (with lots of -vvvv flags - just the Host |
6 |
> Controller bit)? |
7 |
|
8 |
|
9 |
00:1f.2 SATA controller: Intel Corporation 6 Series/C200 Series Chipset |
10 |
Family SATA AHCI Controller (rev 05) (prog-if 01 [AHCI 1.0]) |
11 |
Subsystem: Hewlett-Packard Company 6 Series/C200 Series Chipset Family |
12 |
SATA AHCI Controller |
13 |
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- |
14 |
Stepping- SERR- FastB2B- DisINTx+ |
15 |
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- |
16 |
<TAbort- <MAbort- >SERR- <PERR- INTx- |
17 |
Latency: 0 |
18 |
Interrupt: pin B routed to IRQ 26 |
19 |
Region 0: I/O ports at f070 [size=8] |
20 |
Region 1: I/O ports at f060 [size=4] |
21 |
Region 2: I/O ports at f050 [size=8] |
22 |
Region 3: I/O ports at f040 [size=4] |
23 |
Region 4: I/O ports at f020 [size=32] |
24 |
Region 5: Memory at fb205000 (32-bit, non-prefetchable) [size=2K] |
25 |
Capabilities: [80] MSI: Enable+ Count=1/1 Maskable- 64bit- |
26 |
Address: feeff00c Data: 41d1 |
27 |
Capabilities: [70] Power Management version 3 |
28 |
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) |
29 |
Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME- |
30 |
Capabilities: [a8] SATA HBA v1.0 BAR4 Offset=00000004 |
31 |
Capabilities: [b0] PCI Advanced Features |
32 |
AFCap: TP+ FLR+ |
33 |
AFCtrl: FLR- |
34 |
AFStatus: TP- |
35 |
Kernel driver in use: ahci |