| 1 |
On Sonntag, 17. Februar 2008, Jens Krahe wrote: |
| 2 |
> Am Sonntag, 17. Februar 2008 schrieb Volker Armin Hemmann: |
| 3 |
> > On Sonntag, 17. Februar 2008, Jens Krahe wrote: |
| 4 |
> > > Am Samstag, 16. Februar 2008 schrieb Andrew Gaydenko: |
| 5 |
> > > > Ehci module is loaded, all MB USB ports are USB 2 ports, printer is |
| 6 |
> > > > "USB 2 (Full Speed)" printer. |
| 7 |
> > > |
| 8 |
> > > And there is nothing wrong. EHCI handles only the High Speed mode of |
| 9 |
> > > USB2! Low and Full Speed are still handled by UHCI/OHCI. |
| 10 |
> > |
| 11 |
> > you are wrong, kernel with ehci only: |
| 12 |
> > |
| 13 |
> > [ 31.592651] usb 1-3.1: new low speed USB device using ehci_hcd and |
| 14 |
> > address 4 |
| 15 |
> |
| 16 |
> And the device works? |
| 17 |
> |
| 18 |
31.984912] usb 1-3: new high speed USB device using ehci_hcd and address 2 |
| 19 |
[ 32.109390] usb 1-3: configuration #1 chosen from 1 choice |
| 20 |
[ 32.109727] hub 1-3:1.0: USB hub found |
| 21 |
[ 32.110081] hub 1-3:1.0: 4 ports detected |
| 22 |
[ 32.437368] usb 1-5: new high speed USB device using ehci_hcd and address 3 |
| 23 |
[ 32.566492] usb 1-5: configuration #1 chosen from 1 choice |
| 24 |
[ 32.753643] usb 1-3.1: new low speed USB device using ehci_hcd and address |
| 25 |
4 |
| 26 |
[ 32.856094] usb 1-3.1: configuration #1 chosen from 1 choice |
| 27 |
[ 32.867755] input: Logitech USB Receiver as /class/input/input3 |
| 28 |
[ 32.880583] input: USB HID v1.11 Mouse [Logitech USB Receiver] on |
| 29 |
usb-0000:00:02.1-3.1 |
| 30 |
[ 32.886684] input: Logitech USB Receiver as /class/input/input4 |
| 31 |
[ 32.913844] input: USB HID v1.11 Device [Logitech USB Receiver] on |
| 32 |
usb-0000:00:02.1-3.1 |
| 33 |
|
| 34 |
so it is the mouse/receiver of the mouse. And yes, it works perfectly fine. |
| 35 |
|
| 36 |
I have ohci support compiled as module - but the module is never loaded. |
| 37 |
-- |
| 38 |
gentoo-user@l.g.o mailing list |
Archives