| 1 |
i reboot the system, fresh start with livcd. all reports the same error. :( |
| 2 |
|
| 3 |
i noticed that the hardware address is 3a:3a:2d:6c:3a:3a, which is |
| 4 |
obviously an invalid one. i guess it is a hardware failure... |
| 5 |
|
| 6 |
|
| 7 |
On Fri, Aug 6, 2010 at 8:14 PM, Mick <michaelkintzios@×××××.com> wrote: |
| 8 |
> Run dhcpcd -k and check that dhcpcd does not leave any locks behind. |
| 9 |
> |
| 10 |
> Then run dhcpcd -d eth0 and see what's reported by it. |
| 11 |
> |
| 12 |
> On 6 August 2010 12:57, Xi Shen <davidshen84@××××××××××.com> wrote: |
| 13 |
>> hi, |
| 14 |
>> |
| 15 |
>> after a sudden power cut off, my gentoo system cannot connect to the |
| 16 |
>> network any more... |
| 17 |
>> |
| 18 |
>> the system can be started, but when starting dhcp, it reports "Cannot |
| 19 |
>> assign requested address". if tried ifconfig eth0 up, it reports the |
| 20 |
>> same error. using dmesg|grep eth0 and dmesg|grep network, it shows the |
| 21 |
>> system has detected my network card. |
| 22 |
>> |
| 23 |
>> any idea what is the cause of the problem? |
| 24 |
>> |
| 25 |
>> |
| 26 |
>> -- |
| 27 |
>> Best Regards, |
| 28 |
>> Xi Shen (David) |
| 29 |
>> |
| 30 |
>> http://twitter.com/davidshen84/ |
| 31 |
>> |
| 32 |
>> |
| 33 |
> |
| 34 |
> |
| 35 |
> |
| 36 |
> -- |
| 37 |
> Regards, |
| 38 |
> Mick |
| 39 |
> |
| 40 |
> |
| 41 |
|
| 42 |
|
| 43 |
|
| 44 |
-- |
| 45 |
Best Regards, |
| 46 |
Xi Shen (David) |
| 47 |
|
| 48 |
http://twitter.com/davidshen84/ |
Archives