1 |
On Wednesday 11 Feb 2015 00:43:22 Philip Webb wrote: |
2 |
> 150210 Mick wrote: |
3 |
> > Your desktop hasn't. When the link comes up again nothing kicks in |
4 |
> > to either request an IP address from the DHCP server |
5 |
> > or to self-configure one temporarily. Either enable IPv4LL |
6 |
> > or install ifplug/netplug to achieve the same end result. |
7 |
> > |
8 |
> > On Tuesday 10 Feb 2015 22:36:00 Philip Webb wrote: |
9 |
> >> Thanks for the suggestion, but I still don't know how to proceed. |
10 |
> > |
11 |
> > If you are using dhcpcd it is enabled by default, |
12 |
> > unless you use -L (-- noipv4ll) in /etc/conf.d/net |
13 |
> > Have you disabled this in your desktop, or are you not using dhcpcd? |
14 |
> |
15 |
> Thanks for your patient help (big smile). |
16 |
> AFAICS the config of both machines is the same. |
17 |
> What I have realised (red face) is that while there is a difference, |
18 |
> it is not in resuming the connection after an un/replug, |
19 |
> but in starting Dhcpcd after a reboot : |
20 |
> both machines automatically pick up the connection again after an unplug, |
21 |
> but the netbook starts Dhcpcd automatically after each boot, |
22 |
> whereas the desktop needs to be told to do so via 'dhcpcd'. |
23 |
> |
24 |
> I've searched again for something different between the machines |
25 |
> which would explain why one starts Dhcpcd without being told, |
26 |
> but the other doesn't : I can't see any difference. |
27 |
> 'grep -r dhcp *' in /etc gives the same 2 lines in both machines ; |
28 |
> the netbook's syslog shows it starting Dhcpcd immediately after boot, |
29 |
> while the desktop's syslog shows nothing till I enter 'dhcpcd'. |
30 |
> |
31 |
> IIRC the change happened after the recent update of the netbook, |
32 |
> which I try to keep as close to the desktop system as is possible |
33 |
> (the hardware is different & the netbook doesn't use KDE apps etc). |
34 |
> |
35 |
> Can anyone suggest what mb starting Dhcpcd automatically ? |
36 |
> The logs just show it happening & Htop doesn't show it depending on |
37 |
> anything. |
38 |
|
39 |
Just checking: are your hotplug settings the same between the two machines in |
40 |
/etc/rc.conf? |
41 |
-- |
42 |
Regards, |
43 |
Mick |