| 1 |
On 25.02.2015 00:55, Bob Wya wrote: |
| 2 |
> Super obvious question... but can you enable AHCI mode for your SATA |
| 3 |
> Controller - in the BIOS. |
| 4 |
|
| 5 |
AHCI is enabled in the BIOS, I checked right now. |
| 6 |
Do the messages tell us it isn't? |
| 7 |
|
| 8 |
Ah, I see, no "NCQ" for the SSD ... hmm, right. |
| 9 |
|
| 10 |
> Are you using HP supplied SATA cables - because these may be sucky crap. If |
| 11 |
> so I would try replacing them - especially if they don't have latches on |
| 12 |
> the plugs. |
| 13 |
|
| 14 |
I am not sure, where the cables came from ... the one for the SSD has |
| 15 |
latches. But I will replace the SATA cable and see if it changes things. |
| 16 |
|
| 17 |
> I think this is the specification for your motherboard chipset: |
| 18 |
> http://www.intel.com/content/www/us/en/chipsets/mainstream-chipsets/h67-express-chipset.html |
| 19 |
> So you probably need the decent SATA 3G (6Gbit) cables to get the best |
| 20 |
> support for your SSD. |
| 21 |
> |
| 22 |
> I've had some issues with 6Gbit SATA... Basically you are looking at really |
| 23 |
> high switching speeds - where connector quality makes a huge difference. It |
| 24 |
> might even be worth cleaning out your SATA connectors with isopropyl |
| 25 |
> alcohol (99%). |
| 26 |
|
| 27 |
good hint, thanks! I will report back if I find something. |
Archives