| 1 |
Stroller wrote: |
| 2 |
> |
| 3 |
> On 2 May 2009, at 03:55, Dale wrote: |
| 4 |
>>> ... |
| 5 |
>>> |
| 6 |
>>> [1] http://en.gentoo-wiki.com/wiki/Custom_Stage4#The_TAR_system |
| 7 |
>>> |
| 8 |
>>> |
| 9 |
>> |
| 10 |
>> I'm wanting to print this page, from the link above. Is it me or does |
| 11 |
>> some of the lines run off the edge of the margins and get lost? I have |
| 12 |
>> tried this in both Seamonkey and Konqueror with the same results. I |
| 13 |
>> also tried to copy and paste it to OOo and Kwrite and it cuts it off |
| 14 |
>> too. One line that seems consistent is the line about options not being |
| 15 |
>> used with tar, the -p option. It looks ok on the website but not when |
| 16 |
>> printed. |
| 17 |
> |
| 18 |
> Works fine here using Safari's "print" then "Save as PDF", but a bit |
| 19 |
> whacky when you right-click & choose "export to PDF". The latter would |
| 20 |
> normally print the whole lot as a single page of unrestrained length, |
| 21 |
> but it is blank after the end of the first paragraph ("However, there |
| 22 |
> may be problems with this alternate method if you use the stage4 on |
| 23 |
> systems with different hardware configurations."). I would have |
| 24 |
> expected the latter to be the more reliable print method, TBH. |
| 25 |
> |
| 26 |
> Stroller. |
| 27 |
> |
| 28 |
|
| 29 |
I was just curious if it was a setting or something on my end. Usually |
| 30 |
when both Seamonkey and Konqueror do the same thing then it is not a bad |
| 31 |
setting but it does look like the page should be printable as well. Is |
| 32 |
this a bug that should be reported? I also wonder if this is the only |
| 33 |
page like this? |
| 34 |
|
| 35 |
Dale |
| 36 |
|
| 37 |
:-) :-) |
Archives