1 |
On Fri, 2012-01-06 at 13:36 +0100, Volker Armin Hemmann wrote: |
2 |
> Am Donnerstag, 5. Januar 2012, 23:44:10 schrieb Jeff Cranmer: |
3 |
> > On Fri, 2012-01-06 at 02:42 +0100, Volker Armin Hemmann wrote: |
4 |
> > > in your case |
5 |
> > > |
6 |
> > > sfdisk -d /dev/sdb | sfdisk /dev/sdc |
7 |
> > > |
8 |
> > > of course ;) |
9 |
> > |
10 |
> > One of the disks had a GPT partition table which I was eventually able |
11 |
> > to get rid of with gdisk (emerge -av gptfdisk). |
12 |
> > |
13 |
> > I'm close. I had a 2.7TiB RAID5 array using genkernal, comprising three |
14 |
> > 1.5TB disks, using the commands |
15 |
> > mdadm --create /dev/md0 --level=5 |
16 |
> > --raid-devices=3 /dev/sdb1 /dev/sdc1 /dev/sdd1 |
17 |
> > |
18 |
> > mdadm --detail --scan >> /etc/mdadm.conf |
19 |
> > |
20 |
> > I formatted this array as an xfs filesystem. |
21 |
> > |
22 |
> > After reboot, however, /dev/md0 is still there, but I get a 'can't read |
23 |
> > superblock' error. |
24 |
> > |
25 |
> > What am I missing? |
26 |
> |
27 |
> have you set the type to linux raid autodetect? |
28 |
> |
29 |
> have you tried mdadm --assemble? |
30 |
> |
31 |
mdadm --assemble /dev/md0 didn't make any difference. |
32 |
Where do I set the type? |
33 |
|
34 |
Thanks |
35 |
|
36 |
Jeff |