| 1 |
On Tuesday 29 August 2006 16:21, Michael [Plouj] Ploujnikov wrote: |
| 2 |
|
| 3 |
> I am very sure I enabled all the proper kernel things as described by |
| 4 |
> the printing guide. I also enabled PNP as suggested by someone |
| 5 |
> (http://gentoo-wiki.com/HP_Deskjet_720C_with_CUPS): |
| 6 |
> |
| 7 |
> $ grep -i pnp /boot/config-2.6.17-gentoo-r4 |
| 8 |
> # CONFIG_IP_PNP is not set |
| 9 |
> CONFIG_PNP=y |
| 10 |
> # CONFIG_PNP_DEBUG is not set |
| 11 |
> CONFIG_PNPACPI=y |
| 12 |
> # CONFIG_BLK_DEV_IDEPNP is not set |
| 13 |
> CONFIG_SERIAL_8250_PNP=y |
| 14 |
> $ grep -i par /boot/config-2.6.17-gentoo-r4 |
| 15 |
> CONFIG_ARCH_SPARSEMEM_ENABLE=y |
| 16 |
> # CONFIG_SPARSEMEM_MANUAL is not set |
| 17 |
> # CONFIG_SPARSEMEM_STATIC is not set |
| 18 |
> CONFIG_PM_STD_PARTITION="" |
| 19 |
> # Parallel port support |
| 20 |
> CONFIG_PARPORT=y |
| 21 |
> CONFIG_PARPORT_PC=y |
| 22 |
> # CONFIG_PARPORT_SERIAL is not set |
| 23 |
> # CONFIG_PARPORT_PC_FIFO is not set |
| 24 |
> # CONFIG_PARPORT_PC_SUPERIO is not set |
| 25 |
> # CONFIG_PARPORT_GSC is not set |
| 26 |
> # CONFIG_PARPORT_1284 is not set |
| 27 |
> # CONFIG_PARIDE is not set |
| 28 |
> # CONFIG_SERIO_PARKBD is not set |
| 29 |
> # CONFIG_TIPAR is not set |
| 30 |
> # CONFIG_I2C_PARPORT is not set |
| 31 |
> # CONFIG_I2C_PARPORT_LIGHT is not set |
| 32 |
> # Partition Types |
| 33 |
> # CONFIG_PARTITION_ADVANCED is not set |
| 34 |
> CONFIG_MSDOS_PARTITION=y |
| 35 |
|
| 36 |
Just checking - have you also set CONFIG_PRINTER=y ? |
| 37 |
-- |
| 38 |
Regards, |
| 39 |
Mick |
Archives