1 |
On Sun, 18 Mar 2007 22:32:46 -0400, Fiifi Markin wrote: |
2 |
|
3 |
> unsubscribe |
4 |
|
5 |
Here's how to unsubscribe: |
6 |
|
7 |
First, ask your Internet Provider to mail you an Unsubscribing Kit. |
8 |
Then follow these directions. |
9 |
|
10 |
The kit will most likely be the standard no-fault type. Depending on |
11 |
requirements, System A and/or System B can be used. When operating |
12 |
System A, depress lever and a plastic dalkron unsubscriber will be |
13 |
dispensed through the slot immediately underneath. When you have |
14 |
fastened the adhesive lip, attach connection marked by the large "X" |
15 |
outlet hose. Twist the silver-coloured ring one inch below the |
16 |
connection point until you feel it lock. |
17 |
|
18 |
The kit is now ready for use. The Cin-Eliminator is activated by the |
19 |
small switch on the lip. When securing, twist the ring back to its |
20 |
initial condition, so that the two orange lines meet. Disconnect. |
21 |
Place the dalkron unsubscriber in the vacuum receptacle to the rear. |
22 |
Activate by pressing the blue button. |
23 |
|
24 |
The controls for System B are located on the opposite side. The red |
25 |
release switch places the Cin-Eliminator into position; it can be |
26 |
adjusted manually up or down by pressing the blue manual release |
27 |
button. The opening is self-adjusting. To secure after use, press the |
28 |
green button, which simultaneously activates the evaporator and |
29 |
returns the Cin-Eliminator to its storage position. |
30 |
|
31 |
You may log off if the green exit light is on over the evaporator. If |
32 |
the red light is illuminated, one of the Cin-Eliminator requirements |
33 |
has not been properly implemented. Press the "List Guy" call button on |
34 |
the right of the evaporator. He will secure all facilities from his |
35 |
control panel. |
36 |
|
37 |
To use the Auto-Unsub, first undress and place all your clothes in the |
38 |
clothes rack. Put on the velcro slippers located in the cabinet |
39 |
immediately below. Enter the shower, taking the entire kit with |
40 |
you. On the control panel to your upper right upon entering you will |
41 |
see a "Shower seal" button. Press to activate. A green light will then |
42 |
be illuminated immediately below. On the intensity knob, select the |
43 |
desired setting. Now depress the Auto-Unsub activation lever. Bathe |
44 |
normally. |
45 |
|
46 |
The Auto-Unsub will automatically go off after three minutes unless |
47 |
you activate the "Manual off" override switch by flipping it up. When |
48 |
you are ready to leave, press the blue "Shower seal" release |
49 |
button. The door will open and you may leave. Please remove the velcro |
50 |
slippers and place them in their container. |
51 |
|
52 |
If you prefer the ultrasonic log-off mode, press the indicated blue |
53 |
button. When the twin panels open, pull forward by rings A & B. The |
54 |
knob to the left, just below the blue light, has three settings, low, |
55 |
medium or high. For normal use, the medium setting is suggested. |
56 |
|
57 |
After these settings have been made, you can activate the device by |
58 |
switching to the "ON" position the clearly marked red switch. If |
59 |
during the unsubscribing operation you wish to change the settings, |
60 |
place the "manual off" override switch in the "OFF" position. You may |
61 |
now make the change and repeat the cycle. When the green exit light |
62 |
goes on, you may log off and have lunch. Please close the door behind |
63 |
you. |
64 |
|
65 |
|
66 |
-- |
67 |
Neil Bothwick |
68 |
|
69 |
Everyone has a photographic memory. Some don't have film. |