1 |
В Пнд, 29/06/2009 в 11:30 +0200, Alan McKinnon пишет: |
2 |
> On Monday 29 June 2009 11:29:22 Marco wrote: |
3 |
> > Hi all, |
4 |
> > |
5 |
> > after some updating (emerge --sync and emerge --update --deep world, |
6 |
> > etc.) my wirelss card does not work anymore. |
7 |
> > |
8 |
> > In the boot messagesI have: |
9 |
> > [...] |
10 |
> > * Starting wlan0 |
11 |
> > SIOCSIFFLAGS: No such file or directory |
12 |
> > SIOCSIFFLAGS: No such file or directory |
13 |
> > * Starting wpa_supplicant on wlan0 ... |
14 |
> > SIOCSIFFLAGS: No such file or directory |
15 |
> > SIOCSIFFLAGS: No such file or directory |
16 |
> > Could not set interface 'wlan0' UP |
17 |
> > [ ok ] * Starting wpa_cli on wlan0 ... |
18 |
> > [ ok ] * Backgrounding ... |
19 |
> > [...] |
20 |
> > |
21 |
> > And dmesg shows: |
22 |
> > [...] |
23 |
> > iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 |
24 |
> > iwl3945 0000:03:00.0: restoring config space at offset 0x1 (was |
25 |
> > 0x100102, writing 0x100106) |
26 |
> > firmware: requesting iwlwifi-3945-1.ucode |
27 |
> > iwl3945: iwlwifi-3945-1.ucode firmware file req failed: Reason -2 |
28 |
> > iwl3945: Could not read microcode: -2 |
29 |
> |
30 |
> Did you install the microcode? |
31 |
> |
32 |
> |
33 |
Same problem after install microcode. |