| 1 |
Hi All, |
| 2 |
|
| 3 |
I've run MS Windows update on a dual boot box which has a Realtek |
| 4 |
(RTL-8139/8139C/8139C+ rev 10) card. I thought that the update just updated |
| 5 |
the driver on MS Windows, but I fear it may have messed up the firmware. I |
| 6 |
say this because when I boot in Linux either the 8139too module which is |
| 7 |
built in the kernel (2.6.20-gentoo-r6) does not seem to work, or/and dhcpcd |
| 8 |
times out. |
| 9 |
|
| 10 |
eth0 is not shown under ifconfig by running /etc/init.d/net.eth0 after dhcpd |
| 11 |
times out and it only comes up after I run ifconfig eth0 up. |
| 12 |
|
| 13 |
Has anyone using this card noticed this? Is the kernel driver too old (is |
| 14 |
there a later 8139too module)? |
| 15 |
-- |
| 16 |
Regards, |
| 17 |
Mick |
Archives