| 1 |
J. Roeleveld <joost@××××××××.org> [15-07-29 16:38]: |
| 2 |
> On Wednesday, July 29, 2015 05:18:25 AM Meino.Cramer@×××.de wrote: |
| 3 |
> > Hi, |
| 4 |
> > |
| 5 |
> > the AP is now up and running ... but the the transfer rates are only |
| 6 |
> > about 80 Kb/sec (conky). |
| 7 |
> > |
| 8 |
> > I use an Atheros based USB wifi dongle, create_ap for setup and the |
| 9 |
> > internet connection goes via my PC. There are no other transfers |
| 10 |
> > running (check with wireshark), beside occassional dns and pop3 |
| 11 |
> > communications (very low data amounts) and the PC is nearly |
| 12 |
> > without load (ok...I am typing this email on it, but....;) |
| 13 |
> > |
| 14 |
> > Any way to push this up...? |
| 15 |
> > |
| 16 |
> > Best regards |
| 17 |
> > Meino |
| 18 |
> |
| 19 |
> Which WIFI type are you using? |
| 20 |
> Which USB-type? (USB-1 is dead slow, for instance) |
| 21 |
> |
| 22 |
> Is this speed between both machines? Or to the internet? |
| 23 |
> |
| 24 |
> -- |
| 25 |
> Joost |
| 26 |
> |
| 27 |
|
| 28 |
Hi Joost, |
| 29 |
|
| 30 |
I fired up create_ip like this (just for testing and haveing at least |
| 31 |
ONE experienced succes with this Wifi stuff...): |
| 32 |
|
| 33 |
create_ap wlan0 eth1 <name> <pass> |
| 34 |
|
| 35 |
How can I check for the type of WIFI after the connection has been |
| 36 |
established? |
| 37 |
|
| 38 |
USB is USB 2.0 |
| 39 |
|
| 40 |
The speed is measured by conky, which reads the transfer rate at eth0. |
| 41 |
At that tome, the tablet was getting a greater piece of tar archive |
| 42 |
(LInux for Android) and no other traffic other than this was there. |
| 43 |
The DSL was by far not saturated. |
| 44 |
So physically it is the speed of the internet but logically it is |
| 45 |
nearly identical to what happens at the Wifi interface (I think). |
| 46 |
I will check for an app which displays the speed measured on the |
| 47 |
tablets interface... |
| 48 |
|
| 49 |
Best regards, |
| 50 |
Meino |
Archives