1 |
On Sat, 12 Dec 2009 02:30:18 +0200 |
2 |
Nikos Chantziaras <realnc@×××××.de> wrote: |
3 |
|
4 |
> |
5 |
> I can't offer much help other than the assurance that it works on |
6 |
> 64-bit. I've been using it to keep my CPU's microcode updated for quite |
7 |
> a while. It's a Core 2 Duo though, not Quad, running Gentoo ~amd64. |
8 |
> |
9 |
> |
10 |
|
11 |
Recently I installed Gentoo on another machine that has a Pentium D |
12 |
processor with dual cores. As a test, I tried to update the microcode |
13 |
on this other machine and experienced the exact same behavior. The microcode |
14 |
module required about five minutes to load and the update did not occur. |
15 |
|
16 |
This was quite a surprise to me, but it also tends to indicate that |
17 |
the fault is with the module and the kernel. The module should load |
18 |
immediately and there should be no delay. |
19 |
|
20 |
Possibly there is some additional kernel option that needs to |
21 |
be set but I cannot imagine what it could be. |
22 |
|
23 |
Frank Peters |