Gentoo Archives: gentoo-user

From: Walter Dnes <waltdnes@××××××××.org>
To: gentoo-user@l.g.o
Subject: Re: [gentoo-user] Re: How to configure thochpad sensitivity (using hal)?
Date: Thu, 18 Nov 2010 00:42:34
Message-Id: 20101118004329.GB23732@waltdnes.org
In Reply to: Re: [gentoo-user] Re: How to configure thochpad sensitivity (using hal)? by Alan McKinnon
1 On Wed, Nov 17, 2010 at 02:00:48AM +0200, Alan McKinnon wrote
2
3 > If you then mentioned that their defaults broke Dale's setup, they'd
4 > likely answer "Who's Dale?" followed shortly by "None of us have
5 > hardware like Dale to test. Sorry 'bout that. Set USE=-hal"
6
7 Of course the USE flag advice is given *AFTER* the new flag breaks
8 your system. That's why I use "-*" at the beginning of my USE in
9 /etc/make.conf. I never found out whether hal would break my system<G>.
10 If Dale had used "-*" his X would not have broken, even if some other
11 ebuild pulled it onto the machine as a hard-coded dependancy.
12
13 --
14 Walter Dnes <waltdnes@××××××××.org>

Replies

Subject Author
Re: [gentoo-user] Re: How to configure thochpad sensitivity (using hal)? Alan McKinnon <alan.mckinnon@×××××.com>
Re: [gentoo-user] Re: How to configure thochpad sensitivity (using hal)? Stroller <stroller@××××××××××××××××××.uk>