| 1 |
On Fri, Dec 14, 2012 at 01:24:10PM -0500, felix@×××××××.com wrote: |
| 2 |
> |
| 3 |
> That's what I've been using. |
| 4 |
> |
| 5 |
> But the hardware failure is illogical too; why would USB and SATA fail at the same time? Or why would southbridge fail when it had been running perfectly fine? |
| 6 |
> |
| 7 |
> I don't really think it was 3.7.0, but who knows, did I answer some config question incorrectly and tell it to load some firmware? Without access to the disk, I can't tell. I don't remember any question about loading BIOS firmware, and can't see why the kernel would even care about that. |
| 8 |
> |
| 9 |
> The whole mess makes no sense. |
| 10 |
|
| 11 |
Boot with SystemRescueCd and you can't get to a prompt? |
| 12 |
|
| 13 |
If you do, do you have internet access once you're there? |
| 14 |
|
| 15 |
If neither, take a photo and post a link to a *clear* snapshot. |
| 16 |
|
| 17 |
Yes, your southbridge chipset could just happened to have failed at the same |
| 18 |
time; or it failed on the reboot; or USB and SATA are both on the southbridge |
| 19 |
that failed so you lost both, basically. |
| 20 |
-- |
| 21 |
Happy Penguin Computers >') |
| 22 |
126 Fenco Drive ( \ |
| 23 |
Tupelo, MS 38801 ^^ |
| 24 |
support@×××××××××××××××××××××.com |
| 25 |
662-269-2706 662-205-6424 |
| 26 |
http://happypenguincomputers.com/ |
| 27 |
|
| 28 |
Don't top-post: http://en.wikipedia.org/wiki/Top_post#Top-posting |
Archives