1 |
On Thu, Sep 1, 2011 at 11:52 PM, BRM <bm_witness@×××××.com> wrote: |
2 |
> I still haven't decided what to get for my system to replace the NIC with, but the card I have should be working with my existing 802.11g network already; however, it doesn't - I have had to connect my laptop via Ethernet cable to my wireless bridge to get network access. |
3 |
> |
4 |
> /etc/init.d/net.wlan0 starts, but goes immediately inactive. From what I can find on-line, this seems to have been something common after moving to Base Layout 2/OpenRC; however, I couldn't find anything that specified what the actual solution was - I think most ended up doing a complete reinstall of their wicd/wpa-supplicant software - either way details were lacking. I've successfully had wpa-supplicant working in the past, and as a result of all of this I've tried to get it up through the other method too (iwconfig?), but no success. (I think I have managed to get it to scan some, but not sufficiently and certainly no connections.) |
5 |
|
6 |
Did you followed the instructions at |
7 |
|
8 |
http://www.gentoo.org/doc/en/openrc-migration.xml |
9 |
|
10 |
specifically the network section? |
11 |
|
12 |
> Anyone see this issue and know what the solution is? I'd like to at least get my 802.11g access back - the current setup is a bit of a pain and very limiting. |
13 |
|
14 |
Since you use a laptop, I will assume you have either KDE, GNOME or |
15 |
Xfce. If that's the case, why don't you try NetworkManager or connman, |
16 |
and use the GUI thingy to do the work for you? I haven't manually |
17 |
configured a wireless network in years, and I have been the last three |
18 |
months traveling with my laptop literally all over the world, |
19 |
connecting to all kinds of access points. |
20 |
|
21 |
NetworkMnager just works, but I also hear great comments about connman. |
22 |
|
23 |
Regards. |
24 |
-- |
25 |
Canek Peláez Valdés |
26 |
Posgrado en Ciencia e Ingeniería de la Computación |
27 |
Universidad Nacional Autónoma de México |