From: | karl@××××××××.se | ||
---|---|---|---|
To: | gentoo-user@l.g.o | ||
Subject: | Re: [gentoo-user] Hard drive screws | ||
Date: | Sat, 18 Jul 2020 12:03:14 | ||
Message-Id: | 20200718120305.8EA6D8152C4A@turkos.aspodata.se | ||
In Reply to: | Re: [gentoo-user] Hard drive screws by Dale |
1 | Dale: |
2 | ... |
3 | > the first bag of screws I ordered didn't have any size info |
4 | ... |
5 | |
6 | To figure out which thread one have, one usually use: |
7 | https://en.wikipedia.org/wiki/Calipers |
8 | to get the diameter. Given the diameter, and possible the table of thread |
9 | sizes, one can sufficiently well infer which thread it is. |
10 | |
11 | You can use a thread gauge if unsure: |
12 | https://en.wikipedia.org/wiki/Thread_gauge |
13 | |
14 | Regards, |
15 | /Karl Hammar |
Subject | Author |
---|---|
Re: [gentoo-user] Hard drive screws | Dale <rdalek1967@×××××.com> |